Whirlpool Load And Go Door Locked Light Blinking

Step 2 unplug the washer or trip the circuit breaker.

Whirlpool load and go door locked light blinking.

Select and hold end of cycle signal for 3 seconds. Avoid trying to force the door open by pulling on it or by using tools to pry it open. To do that pull the washer forward and unplug it. Our chat service hours are monday friday from 8 a m.

1 press wash temp then spin then soil buttons one after the other. Remove the screws coming in from the back of the top panel. No matter what cycle i choose except for rinse and drain it starts the cycle locks the door then a few seconds into the cycle after getting everything wet it stops washing and starts beeping three beeps pause three beeps pause etc. Other than that you ll need to manually unlock the door.

Use a t 20 torx screwdriver to remove the three torx head screws along the bottom front of the washer. The panel will come to life error codes will flash and the humming sound will continue. The only thing you can possibly accomplish doing this is to break the door the lock or both resulting in a hefty repair bill. To unlock the controls select and hold end of cycle signal for 3 seconds until the control locked status light turns off.

The control locked status light glows. If that doesn t work then the 3 buttons are spin then soil then presoak this worked on my washer. Thank you for your inquiry. When the lock light is blinking it typically means that the unit either took to long to fill with water in which case it ll go into flood mode and keep draining for 15 20 minutes and unlock on it s own or there is a glitch in the electronics and just unplugging it for 60 seconds will reset the issue.

First try to just unplug the washer for 60 seconds or flip the circuit breaker off to the washer and usually the control panel will reset and the door lock light will stop flashing.