Which Way To Tighten My Liftmaster Spring Tension Garage Door

Tighten the adjuster three full turns clockwise to add tension if the door closed and did not remain open halfway.

Which way to tighten my liftmaster spring tension garage door.

Garage door springs offset the weight of the door and allow it to open and close with ease. If your winding bar slips while you tighten or loosen the spring the spring immediately releases hundreds of pounds of tension. This cone has notches in it that are used to adjust the tension in the torsion spring. Once the spring is free of tension remove from its track hanger.

A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem. Loosen the adjuster three turns counterclockwise if the door raised without. Slowly close your door about halfway and release it. Release your hold on the door and see if it stays up all the way.

So in most cases you should call a garage door expert to deal with your broken springs. Step 2 use a metal rod to stick in the first notch of the cone. If it was opening too quickly move it to the next lower hole. The heavier your garage door the greater the spring s tension and the greater the spring s capacity to seriously harm you.

This can make the other parts of the garage door last a much longer time. If the door was closing too quickly move the spring to the next higher hole on the bracket. This will increase the tension on the spring so the door is easier to open and doesn t slide closed on its own. This tension makes it easier to lift the garage door from its closed position.

The cone is on the torsion spring on the left side away from the center of the garage door. The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel. Tighten the tension on the spring 1 4 of a turn if the door is closing on its own. Rotate the adjusting collar about 1 4 of a turn up using the torsion spring winding bar.

Ideally the door should slowly float up from this point. Side mounted springs are long heavy springs mounted on each side of the upper garage door track.